BOOM Watch two year International Warranty 

Thank you for your purchase of a watch from the BOOM Watch Collection, which we hope will bring you great pleasure. We want to assure you that your new BOOM watch is made and tested to meet our highest quality standards. We guarantee that this watch from the BOOM Watch Collection has been manufactured with the greatest possible care.

The manufacturer’s warranty covers BOOM Watches to the original consumer for a period of two (2) years from the date of purchase. Our warranty covers the purchased watch for defects in materials and workmanship under normal use. Please note that this warranty does not cover damage caused by abrasion, scraping, careless or neglectful treatment or accidents. Please note that this warranty does not include wear and alteration to the case, strap or bracelet, and crystal (lens) or water damage (unless marked “water resistant” on back case).

Water resistant 3 ATM: Does not resist showers and suchlike.

Water resistant 5 ATM: Resists showers and suchlike but it will not resist swimming.

Extended warranty

You have the possibility to extend your warranty to a three year international warranty by registering your purchase on www.boomwatches.com/mywatch. Claims under warranty can only be made by returning the watch to an official BOOM Watch centre, (addresses can be found at http://www.boomwatches.com/where-to-buy).

If the damage turns out to be due to a manufacturing defect, the watch will be replaced under warranty. If not, you will receive an estimation for the cost of repairs prior to any repair work being carried out on the watch. For further help you can also contact our Customer Service Department by using the contact form on our website: www.boomwatches.com or by phone +46 (0)18-XXX XXX.

Note: This International Warranty does not in any way cancel, restrict or otherwise affect any legally recognised consumer right or privilege in the country of purchase of the BOOM Watch.


Adjusting your BOOM Watch 

1. Pull the crown/winder out until you hear a gentle click.

2. Turn the crown/winder to set the time as desired.

3. Push in the crown completely and you are done! 

Assembling your BOOM Watch

1. Insert the dial container into the case from behind. Make sure the crown/winder stem is aligned correctly so that it fits neatly into the cutout on the side.

2. Lay your watch down with the dial facing upwards.

3. Place the top ring over the dial and line it up so that all of the watch face is visible.

4. Screw the top ring in place on the dial container. Be careful not to over-tighten it.

Fitting classic 2 part straps

For classic 2 part straps, attach each strap by inserting the push pins on the end of the strap into the small holes in the case. 

Fitting NATO 1 piece straps

Insert the supplied push pins first. Then thread the strap over the pin, under the dial container and then over the second pin and finally through the metal loop.

Now you can enjoy wearing your BOOM Watch!

Det finns inte tillräckligt av dessa artiklar. Endast [max] vänster.
Bläddra i önskelistaTa bort önskelista


Din vagn är tom.

Fortsätt handla